If you cannot fit two pieces of paper between the extruder nozzle and print bed, use the Z-offset figures to increase the gap by 0.1mm increments and click accept. software for pipe stress analysis including ANSYS, CAESAR II, NozzlePRO. Consult the table in the instruction manual to know where each cable should be plugged. 2 pressure vessel stress requirements Design cooler nozzle loads to meet. Connect the Cables All the cables of the Longer LK5 Pro are market with letters. Mount the Touchscreen Use two screws to fix the touchscreen at the base. Go Setting → Z offset to set the Z offset manually move the nozzle to the middle, the ideal distance between extruder nozzle and print bed should be two standard A4 sheets of paper. The holder protrudes to the rear at a 45° angle.Check if the tape has been scratched or not if the distance between extruder nozzle and the print bed is too close, press Home axes again to move the extruder back to the initial position, then proceed to the step below.Move the extruder module to the middle of the print bed using the onscreen buttons.The extruder will go back to its original position. Connect the DisplayPort cable to the dedicated graphics card on your computer.

Connect the USB 3.0 cable to a USB port on your computer. Connect the USB 3.0 cable, DisplayPort cable and power cable to the link box and to a power outlet. In the printing monitor go to SetUp → jog mode → home axis → Finished. Find the link box and check its components.Finite Element Analysis (FEA) We use FEA to design and. If you are still having problems try manually adjusting the Z offset We use Compress, PV Elite, Design Calcs, Nozzle Pro and our own in-house software. The distance between the extruder nozzle and the printing bed may be too close, attach bed tape and calibrate the da Vinci Mini.

Nozzle pro software working guide